Nortel Networks 1000E warranty Entering IP Phone boot parameters using full Dhcp parameters

Installing and configuring IP Phones Page 428 of 488

17Enter the IP Phone’s (virtual) TN.

The IP Phone displays the logo, the date and time, and the DN keys.

18Check for dial tone and the correct DN above the display.

End of Procedure

Entering IP Phone boot parameters using full DHCP parameters

Follow Procedure 108 to enter IP Phone boot parameters using full DHCP parameters.

Procedure 108

Entering IP Phone boot parameters using full DHCP parameters

1Power the IP Phone.

Within four seconds, the Nortel logo appears.

2When the Nortel logo appears on the display, you have one second to press the four feature keys at the bottom of the display in sequence, from left to right.

Note: If the Nortel logo times out, repeat step 1 and step 2.

3For the following prompts:

a.Press the BKSpace (backspace) or Clear keys to change an entry.

b.Enter new values using the telephone’s keypad.

c.Press the OK key to accept your selection.

The IP Phone prompts:

DHCP? (0-No, 1-Yes): 0

4Enter 1 to use DHCP. The IP Phone prompts:

DHCP:0-Full, 1-Partial:0

5Enter the 0 to use Full DHCP. The IP Phone prompts:

VLAN?(0-No,1-Ma,2-Au)0

Communication Server 1000E Installation and Configuration