Nortel Networks 1000E warranty Configuring Digitone Receivers

Page 214 of 488 Configuring the CS 1000E Call Server

LD 97 – Configuring the MG 1000E ports (Part 2 of 2)

Prompt	Response	Comment
ZONE0	0-255	First MG 1000E zone number
VXTC0	l x	First MG 1000E Virtual conference circuit starting loop
		number. Two consecutive VXCTs are assigned.
		The VXCTs must be previously configured in LD 17.
		Where:
		l = 0-252
		x = 0 means 1 TDS loop only.
		x = 1 means 1 TDS loop and 1 conference loop.
		x = 2 means 2 TDS loops and 2 conference loops.
		x = 3 means 2 TDS loops and 3 conference loops.
		x = 4 means 2 TDS loops and 4 conference loops.
		Precede with X to remove.
IPR1	xx.xx.xx.xx	IP address of second MG 1000E cabinet uplink IP address;
		<cr> to skip to IPR2 when configuring new superloop.
ZONE1	0-255	Second MG 1000E zone number
VXCT1	l x	Second MG 1000E Virtual conference circuit starting loop
		number. Two consecutive VXCTs are assigned.
		The VXCTs must be previously configured in LD 17.
		Where:
		l = 0-252
		x = 0 means 1 TDS loop only.
		x = 1 means 1 TDS loop and 1 conference loop.
		x = 2 means 2 TDS loops and 2 conference loops.
		x = 3 means 2 TDS loops and 3 conference loops.
		x = 4 means 2 TDS loops and 4 conference loops.
		Precede with X to remove.

Configuring Digitone Receivers

Digitone Receivers must be configured in each MG 1000E if any analog terminals or trunks are equipped. The loop of the Digitone Receivers is the

553-3041-210 Standard 4.00 September 2007