Nortel Networks 1000E warranty Signaling Server SDI connection

Configuring a terminal and SDI ports Page 273 of 488

Signaling Server SDI connection

The Signaling Server has two maintenance ports: the Front port and the Console port (see Figure 89). The Console port must be used to install the Signaling Server software to perform the basic configuration.

Figure 89

Signaling Server maintenance port locations

Front port Console port

Procedure 70

Connecting the maintenance PC to a Signaling Server

1Connect a DTE–DTE null modem serial cable (supplied with the Signaling Server) from the Console port to a PC workstation.

Note: The Signaling Server is shipped with the Admin/Serial port set to 19200 bit/s.

During the initial installation, the unit requires the PC Maintenance terminal settings as provided in Step 2 on page 274.

Communication Server 1000E Installation and Configuration