Nortel Networks 1000E warranty Procedure Connecting an off-premise telephone

Page 390 of 488 Installing Line cards and cross-connecting telephones

Procedure 100

Connecting an off-premise telephone

1Install the NTAK92BA Off-Premise Protection Module on the wall using four #10 1/2-in (minimum) screws.

2Connect a #6 AWG from the grounding lug at the bottom of the NTAK92AA Off-Premise Protection Module to the system ground. Refer to Figure 143 on page 391.

DANGER OF ELECTRIC SHOCK

If connecting to a message-waiting Line card, unseat the card from its assigned slot before continuing with the next step.

3Connect two NTAK9204 cables (one from connector J1 and one from connector J2) from the protection module to the cross-connect terminal.

4Terminate the cables as shown in Figure 141 on page 387.

5Cross-connect the J1 cable to the Tip and Ring connections coming from the Line card.

6Cross-connect the J2 cable to the off-premise telephone.

7Install the regulatory label provided with the Off-Premise Protection Module on the inside right-hand wall of the Media Gateway.

8Install the Line card in its assigned position.

9Activate the telephone.

553-3041-210 Standard 4.00 September 2007