Nortel Networks 1000E warranty Leader/Follower Signaling Server configuration

Installing and configuring the Signaling Server software Page 185 of 488

9Configure the Signaling Server as Leader or Follower. See Figure 62.

•If there is not already a Leader Signaling Server in the IP Telephony node, or if the Signaling Server is to be a stand-alone Signaling Server, enter a at the prompt to configure this Signaling Server as Leader.

•If there is already a Leader Signaling Server in the IP Telephony node, enter b at the prompt to set this Signaling Server as Follower. Then go to step 13 on page 189.

For more information about Leader and Follower Signaling Servers, see

IP Line: Description, Installation, and Operation (553-3001-365).

Figure 62

Leader/Follower Signaling Server configuration

CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)

=====================================================================

Note: This step will over-write all existing configuration parameters on this Signaling Server.

Please select the role of this Signaling Server.

If this Signaling Server will be a Leader then its data networking and IP Telephony parameters must be entered now. (This will pre- configure the IP Telephony node files.)

If this Signaling Server will be a Follower then its data networking and IP Telephony parameters must be configured through Element Manager later.

Please enter:

<CR> -> <a> - Set this Signaling Server as a Leader. <b> - Set this Signaling Server as a Follower. <q> - Quit.

Enter Choice>

Communication Server 1000E Installation and Configuration