Nortel Networks 1000E warranty Connectivity and power requirements

Installing and configuring IP Phones Page 407 of 488

Connectivity and power requirements

Each IP Phone requires:

•a dedicated 10BaseT or 100BaseT or 10/100BaseT Ethernet interface

•a small desktop hub or switch if sharing an existing desktop Ethernet connection with a PC.

•a local power supply appropriate for the voltage in the area or a Power over LAN unit. (The IP Phone 2002 comes with a built-in 3-port switch and is ready for LAN powering.)

Installation and configuration procedures

This chapter contains the following procedures:

•Procedure 102: "Configuring VoIP bandwidth management zones using the CLI" on page 408

•Procedure 103: "Configuring virtual superloops" on page 410

•Procedure 104: "Configuring the IP Phones" on page 411

•Procedure 105: "Setting passwords for the administrator and temporary IP Telephone Installer" on page 417

•Procedure 106: "Installing IP Phone hardware components" on page 420

•Procedure 107: "Entering IP Telephone boot parameters using manual configuration" on page 425

•Procedure 108: "Entering IP Phone boot parameters using full DHCP parameters" on page 428

•Procedure 109: "Entering IP Phone boot parameters using partial DHCP parameters" on page 430

•Procedure 110: "Using Set-Based Installation" on page 433

•Procedure 111: "Configuring the IP Softphone 2050" on page 436

•Procedure 112: "Installing the USB Headset Kit" on page 437

•Procedure 113: "Installing the IP Softphone 2050 on your PC" on page 437

Communication Server 1000E Installation and Configuration