Nortel Networks 1000E warranty Basic system telephony configuration, Basic system configuration

484

Page 477 of 488

Basic system telephony configuration

Contents

This section contains information on the following topics:

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 479

Basic system configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 479

MG 1000T card slot assignment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 484

TN assignment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 485

Introduction

This chapter shows overlay (LD) sequences required to configure the system with basic telephony features. Your Planning and Engineering group provides the details needed to configure basic telephony.

Note: The Command Line Interface (CLI) must be used for some configuration (for example, LD 10 and LD 11) before Element Manager can be used to further configure basic telephony.

This chapter contains Procedure 123: "Configuring the basic system" on page 480.

Basic system configuration

Programming the CS 1000E and MG 1000T systems requires loading different overlay programs and using each one to enter a specific type of information.

Communication Server 1000E Installation and Configuration