Nortel Networks 1000E warranty 434 of 488 Installing and configuring IP Phones

Page 434 of 488 Installing and configuring IP Phones

Node: x

TN: x.x

1Enter the node number and the IP Phone's (virtual) TN, then go to Step 4. If you configured an IP Phone Installer Password, the IP Phone prompts:

Node: x

PassWord: 0

2Enter the node number and the temporary or administrator IP Phone Installer Password.

Note 1: An asterisk is displayed for each password digit entered; the actual password is not displayed.

Note 2: If this screen times-out, or if you do not successfully enter the password in 3 attempts, the IP Phone continues its registration process as if no entry had been made to this prompt. You can reboot the telephone and try again if more tries are needed.

The IP Phone prompts:

TN: x.x

3Enter the IP Phone’s (virtual) TN.

4Press the OK key.

The IP Phone responds Unequipped...

5Lift the handset. The system accepts the TN.

6Listen for the continuous dial tone.

The system response, displayed on the IP Phone, is as follows: Model ? (20)

7Press the # key to select the default model, or enter the model number and press #.

8Listen for a special tone.

The system response, displayed on the IP Phone, is as follows: OK, ZONE? (0)

9Press the # key to select the default zone, or enter the zone number and press #.

The system response, displayed on the IP Phone, is as follows:

553-3041-210 Standard 4.00 September 2007