Nortel Networks 1000E warranty Connecting MG 1000T system components Page 163

Connecting MG 1000T system components Page 163 of 488

Connecting a Signaling Server to the TLAN subnet

Follow Procedure 37 to connect a Signaling Server to the TLAN subnet.

Procedure 37

Connecting a Signaling Server to the TLAN subnet

1Connect a standard CAT5 cable to the TLAN network interface connector (top) RJ-45 jack on the back of the Signaling Server, see Figure 43 on page 162.

2Connect the other end of the standard CAT5 cable to an RJ-45 TLAN network interface on the data network switch (BayStack 470-24T).

End of Procedure

Inserting a Shielded 50-pin to Serial/ELAN/TLAN adapter onto a Media Card

The Shielded 50-pin to Serial/ELAN/TLAN adapter, shown in Figure 44 on page 164, provides access to the TLAN and ELAN Ethernet Ports. The adapter breaks out the signals from the I/O connector to the following:

•ELAN (management) network interface

•TLAN (telephony) network interface

•one RS-232 (local console) port

Communication Server 1000E Installation and Configuration