Nortel Networks 1000E Installing the software, Procedure Installing the Signaling Server software

Page 172 of 488 Installing and configuring the Signaling Server software

files. If you cannot create a CD, refer to the CD writer's software documentation.

Once the CD is created, you can use it to install new software or to upgrade software on an existing Signaling Server.

Installing the software

Before proceeding, you must complete Procedure 16 on page 111 and

Procedure 17 on page 112.

Procedure 44

Installing the Signaling Server software

After you complete step 1 below, this procedure takes approximately 20 minutes.

1From your Planning and Engineering group, obtain the following network and IP Telephony data for this Signaling Server:

•node ID for the IP Telephony node

•node IP address for the IP Telephony node

•hostname for the Signaling Server

•ELAN network interface IP address, Subnet mask, and Gateway

•TLAN network interface IP address, Subnet mask, and Gateway

•ELAN network interface IP address of the Call Server

•Primary and Alternate NRS IP addresses for this networked system (refer to IP Peer Networking: Installation and Configuration (553-3001-213))

•NRS role, if applicable (refer to IP Peer Networking: Installation and Configuration (553-3001-213))

2Insert the Software CD-ROM into the Signaling Server CD drive, and press the RST button on the front panel to cold-reboot the Signaling Server.

Note: The Software CD-ROM should be bootable. If not, create a boot floppy using the files in the /mkboot directory on the Signaling Server Software CD-ROM.

553-3041-210 Standard 4.00 September 2007