Nortel Networks 1000E warranty Configuring the Terminal Server IP address

Connecting a Terminal Server Page 257 of 488

a.Set baud rate to 9600.

b.Set data bits to 8.

c.Set parity to none.

d.Set stop bit to 1.

e.Set flow control to “None”.

f.Set Terminal Emulation to VT100.

g.Press <CR> until you receive a log-in prompt.

5Log in to the Terminal Server. Enter:

ACCESS

6Enter the user name. Enter:

ADMIN

7Set privileged mode. Enter:

SET PRIV

8Enter the password. Enter:

SYSTEM

End of Procedure

Configuring the Terminal Server IP address

Procedure 63

Configure IP address for the Terminal Server

Note: The IP address can be configured or changed only from local management port 20.

1Configure the Terminal Server’s IP address. At the In-Reach_Priv prompt. Enter:

define server ip address [ip address]

2Configure the Terminal Server’s IP subnet mask. Enter: define server ip subnet mask [ip address]

3Configure the Terminal Server’s IP primary gateway address. Enter:

Communication Server 1000E Installation and Configuration