Nortel Networks 1000E warranty Adding a 100BaseT daughterboard dual port, End of Procedure

Configuring a Small System Controller Page 227 of 488

Procedure 56

Installing an SSC NTM400 Software daughterboard and NTDK57 (NT_REM) remote security device

CAUTION WITH ESDS DEVICES

Static electricity can damage circuit cards. Wear an antistatic wrist strap when handling circuit cards or any of their components.

1Unpack the NTDK20 SSC, and set it aside on a clean surface.

2Install the NTM400 Software daughterboard in the appropriate connector, as shown in Figure 84 on page 233.

3Press firmly on the standoffs to ensure that the NTM400 Software daughterboard is secured to the SSC.

4Insert the NTDK57 (NT_REM) Security Device with NT_REM facing out. See Figure 84 on page 233.

5Repeat procedure for each SSC.

End of Procedure

Adding a 100BaseT daughterboard (dual port)

Follow Procedure 57 to add a 100BaseT daughterboard (dual port) to an SSC.

Procedure 57

Adding a 100BaseT daughterboard (dual port) to an SSC

CAUTION WITH ESDS DEVICES

Static electricity can damage circuit cards. Wear an antistatic wrist strap when handling circuit cards or any of their components.

1Unpack the 100BaseT daughterboard (dual port) and the NTDU0606 cable.

2Using the two NTDU0606 CAT5 Ethernet cables provided:

Communication Server 1000E Installation and Configuration