Nortel Networks 1000E warranty Flow charts, Procedure Configuring the basic system

Page 478 of 488 Basic system telephony configuration

See Software Input/Output: Administration (553-3001-311) for information about overlays.

Flow charts

Figure 160 on page 481 shows the programming overlay (LD) sequence for a new system. The Data-entry-sequence flowchart does not show all possible administration overlays.

In some cases, you must move back and forth between overlays to complete the programming. For example, you must program the Customer Data Block (CDB) before you program the attendant console. However, there are console-related prompts in the CDB that cannot be programmed until you have programmed an attendant console. Skip the console-related prompts, complete the CDB programming, then return to the CDB after the console is programmed. Finish the CDB console-related prompts. A similar situation exists with the Speed Call lists and the Telephones. You must activate the Speed Call list(s) before you can assign the list(s) to a telephone.

Figure 161 on page 482, and Figure 162 on page 483 show overlay titles and gate openers for each feature group. A gate opener enables users to program a related group of features without stepping through all prompts of an overlay. NTP references are shown in the flowchart shaded boxes for those features and options beyond the scope of this guide.

Procedure 1

Configuring the basic system

Use the overlays to configure basic system features offered by the CS 1000E.

1Complete the configuration using the overlays in the order shown in Figure 160 on page 481, Figure 161 on page 482, and Figure 162 on page 483.

553-3041-210 Standard 4.00 September 2007