Nortel Networks 1000E warranty 254 of 488 Connecting a Terminal Server

Page 254 of 488 Connecting a Terminal Server

Up to 16 TTY ports can be configured with the CS 1000E Call Server. The Terminal Server can be used as a central point to manage several devices through their serial ports.

The CS 1000E system currently supports the MRV IR-8020M-101 commercial Terminal Server only.

The MRV IR-8020M-101 Terminal Server is used with the CS 1000E system to provide serial connections for accessing the CS 1000E COM ports. The user can access each COM port from a local PC through telnet sessions or from a remote PC by dialing the on-board modem.

The Terminal Server provides IP connections to each Pseudo TTY (PTY) ports 0-15 for monitoring CDR and traffic reports.

The MRV IR-8020M-101 Terminal Server is supported by the CS 1000E system. The IR-8020M-101 – In-Reach Standalone has 20 Console Ports and a V.90 internal modem. A 19-inch rack-mount kit is provided with the unit.

On the MRV IR-8020M-101 Terminal Server, port 20 is the default management port. It will be used for primary configuration of the IP address, mask address and gateway address. Port 20 is reserved for configuring the Terminal Server in a CS 1000E system. Port 1 to 19 can be configured for Serial Data Interface for the CSE1000E system components.

IMPORTANT!

Before connecting the Terminal Server to another component of the CS 1000E system, read and understand the documentation provided by the Terminal Server’s manufacturer.

This chapter contains the following procedures:

•Procedure 62: "Connecting a Terminal Server to the system" on page 256

•Procedure 63: "Configure IP address for the Terminal Server" on page 257

•Procedure 64: "Run telnet from PC" on page 258

553-3041-210 Standard 4.00 September 2007