Nortel Networks 1000E warranty Chassis support bracket

Page 84 of 488 Rack-mounting the components

Note: The Front Mount Bracket assembly is not intended for use as a slide rail system. The Signaling Server must be firmly attached to the rack.

WARNING

2Align the end of the rail with the flange (B) toward the rear of the Signaling Server. See Figure 20 on page 84.

Figure 20

Chassis support bracket

3Align the screw holes in the rack-mount rail to the mating holes in the side of the Signaling Server chassis. Use three screws (C) on each side.

Note: Hand-tighten the screws to prevent cross-threading, then use a Phillips screwdriver to secure them.

4Attach the bezel door to the faceplate of the Signaling Server, as shown in Figure 21 on page 85 and Figure 22 on page 85.

553-3041-210 Standard 4.00 September 2007