Nortel Networks 1000E warranty Installing the Main Distribution Frame, Contents

364

Page 353 of 488

Installing the Main Distribution Frame

Contents

This section contains information on the following topics:

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 353

Terminal block requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 354

Installing a BIX cross-connect terminal . . . . . . . . . . . . . . . . . . . . . . . . 354

Installing a Krone Test Jack Frame for the UK . . . . . . . . . . . . . . . . . . 356

Connecting the cables to the Media Gateways . . . . . . . . . . . . . . . . . . . 360

Introduction

This chapter describes how to install and connect a CS 1000E system using the BIX, or Krone Test Jack Frame (UK) cross-connect terminals.

This chapter contains the following procedures:

1Procedure 89: “Installing a BIX cross-connect terminal” on page 354.

2Procedure 90: “Installing the Krone Test Jack Frame (UK)” on page 358.

3Procedure 91: “Connecting the cables to the Media Gateways” on page 360.

Note: The use of the BIX system is not mandatory; however, it is the recommended option.

Communication Server 1000E Installation and Configuration