Nortel Networks 1000E warranty Configuring Tone Detectors, MFR, MFC, MFE, MFK5, MFK6 units on card

Configuring the CS 1000E Call Server Page 215 of 488

superloop of the MG 1000E. The first MG 1000E in the superloop is on shelf 0, and the second MG 1000E’s on shelf 1. Sixteen units of DTMF tone detection (DTR) are integrated within the controller (SSC) circuitry, or eight Digitone Receiver units can be configured on each of card 14 and card 15. These Digitone Receiver units are built in on the SSC card in the MG 1000E. No additional hardware is required. If Digitone Receivers units are configured in any other card slots, a receiver hardware pack must be equipped in the slot. If no hardware is equipped, the unequipped receiver units may be allocated during call processing, resulting in call failure.

Any additional tone signaling resources must be added and configured as IPE cards.

Configure Digitone Receivers in LD 13.

LD 13 – Configure the Digitone Receivers

Prompt	Response	Comment
REQ	NEW CHG	Add or change the existing data.
TYPE	a...a	Type of data block (a...a = DTR, MFC, MFE, MFK5, MFK6,
		or MFR)
TN	l s c u	Terminal Number
		l = loop for CS 1000E system. MG 1000E requiring Digitone
		Receivers.
		s = 0 or 1
		c = 14 or 15 to access the integrated MG 1000E tone
		circuits
		u = 0-7	DTMF detectors (DTR)
		0-3	MFR, MFC, MFE, MFK5, MFK6 units on card 15

Configuring Tone Detectors

Tone Detectors, when required, are configured in a manner similar to that for Digitone Receivers. The SSC card in the MG 1000E provides four units of Multifrequency Senders and Receivers. These units are configured on card 15

Communication Server 1000E Installation and Configuration