Nortel Networks warranty Installing software on an MG 1000E SSC

Page 236 of 488 Installing software on an MG 1000E Small System Controller

Installing software on an MG 1000E SSC

The MG 1000E is shipped with a pre-programmed software daughterboard that must be mounted on the SSC.

IMPORTANT!

Before proceeding, ensure that the required hardware is correctly installed and that all connections are secure.

Procedure 59

Installing software on an MG 1000E SSC

1Confirm that the outlet is providing the correct voltage. Refer to the label at the back of the equipment.

2Connect the power cord from the power connectors at the back of the MG 1000E to an AC power source.

3Ensure that the system terminal (TTY) is connected to the cable marked “port 0” on the NTBK48 3-port cable of the Media Gateway.

4Turn the Media Gateway power switch to “ON”.

System response:

Current system time and date :

2/14/2096 6:19:00

Enter new time (hh:mm:ss) : 14:41:00

Enter new date (mm/dd/yy) : 06/03/04

14:41:0 -- 6/3/2004 is the new system time and date.

Is this correct? (y/n/[a]bort) : y

q]uit, [h]elp or [?], <cr> - redisplay

553-3041-210 Standard 4.00 September 2007