Nortel Networks 1000E warranty 96 of 488 Installing system grounds

Page 96 of 488 Installing system grounds

•the Signaling Server power cord is plugged into a wall AC outlet. The Signaling Server is grounded outside of the rack using the safety grounding conductor in the power cord. This method ensures proper grounding only of the Signaling Server itself. It does not provide grounding protection for other rack-mounted pieces of equipment. Therefore, ensure that other devices in the rack are properly grounded as required.

Grounding a Media Gateway powered by the same electrical panel

Follow Procedure 8 to ground one or more Media Gateway powered by the same electrical panel.

Procedure 8

Grounding Media Gateways powered by the same electrical panel

1Disconnect the AC power cord from the power outlet.

2Install a #6 AWG ground wire from the ground lug, as shown in Figure 27 on page 97, at the back of the Media Gateway to the ground bar.

3Place a DO NOT DISCONNECT tag on the ground wire.

553-3041-210 Standard 4.00 September 2007