Nortel Networks 1000E Test the Call Server, Install the software on the second Call Server

Installing software on the CS 1000E Page 141 of 488

3Wait for “DONE” and then “INI” messages to display before you continue.

End of Procedure

Test the Call Server

Procedure 26

Testing the Call Server

1Verify that the Call Server is active.

LD 135 Load program

STAT CPU Get the status of the CPUs

2Check dial-tone.

3Verify that the Call Server is active, redundant, and single.

4Make internal, external, and network calls.

5Check attendant console activity.

6Check IP Peer networking for incoming and outgoing calls.

7Check applications (CallPilot, Symposium, and so on).

End of Procedure

Install the software on the second Call Server

Procedure 27

Installing the software on the second Call Server

1Attach the LAN 1 and LAN 2 cables to the CP PIV faceplate connectors between the Call Servers.

2Complete procedures 22 through 27 for the second Call Server.

3Each Call Server can be named: Call Server 1 and Call Server 0.

Note: Do not install LAN 1 and LAN 2 cables at this time.

End of Procedure

Communication Server 1000E Installation and Configuration