Nortel Networks 1000E warranty Connecting a Signaling Server to the Elan subnet

Connecting CS 1000E system components Page 111 of 488

Procedure 15

Connecting an MG 1000E in the Dual Homed configuration

1Connect logical port 2 of the MG 1000E 100BaseT daughterboard #2 to the bulkhead connector #2. Connect the 100BaseT Port 2 at the back of the Media Gateway to a second BayStack 470.

For CS 1000E systems, it is recommended that there be no single point of failure for the data network. For information on engineering the data network, refer to Converging the Data Network with VoIP (553-3001-160).

End of Procedure

Connecting a Signaling Server to the ELAN subnet

Follow Procedure 16 to connect a Signaling Server to the ELAN subnet.

Procedure 16

Connecting a Signaling Server to the ELAN

1Connect one end of a standard CAT5 cable to the ELAN network interface (bottom) at the back of the Signaling Server, as shown in Figure 33 on page 112.

2Connect the other end of the standard CAT5 cable to an RJ-45 ELAN subnet port on the ELAN Layer 2 switch (BayStack 470-24T).

Communication Server 1000E Installation and Configuration