Nortel Networks 1000E warranty Entering IP Phone boot parameters using manual configuration

Installing and configuring IP Phones Page 425 of 488

Entering IP Phone boot parameters using manual configuration

Follow Procedure 107 to enter IP Telephone boot parameters using manual configuration.

Procedure 107

Entering IP Telephone boot parameters using manual configuration

1Power the IP Phone.

Within four seconds, the Nortel logo appears.

2When the Nortel logo appears on the display, you have one second to press the four feature keys at the bottom of the display in sequence, from left to right.

Note: If the Nortel logo times out, repeat step 1 and step 2.

3For the following prompts:

a.Press the BKSpace (backspace) or Clear keys to change an entry.

b.Enter new values using the telephone’s keypad.

c.Press the OK key to accept your selection.

The IP Phone prompts:

DHCP? (0-No, 1-Yes): 0

4Enter 0 for manual boot parameter configuration. The IP Phone prompts:

SET IP: x.x.x.x

5Enter the IP Phone IP address. The IP Phone prompts:

NETMSK: x.x.x.x

6Enter the subnet mask. The IP Phone prompts:

DEF GW: x.x.x.x

Communication Server 1000E Installation and Configuration