Nortel Networks 1000E warranty End of Procedure

Installing and configuring IP Phones Page 430 of 488

9Enter the node number and the temporary or administrator IP Phone Installer Password.

Note 1: An asterisk is displayed for each password digit entered; the actual password is not displayed.

Note 2: If this screen times out, or if you do not successfully enter the password in three attempts, the IP Phone continues its registration process as if no entry had been made to this prompt. You can reboot the telephone and try again if more tries are needed.

The IP Phone prompts:

TN: x.x

10Enter the IP Phone’s (virtual) TN.

The IP Phone displays the logo, the date and time, and the DN keys.

11Check for dial tone and the correct DN above the display.

End of Procedure

Entering IP Phone boot parameters using partial DHCP parameters

Follow Procedure 109 to enter IP Telephone boot parameters using partial DHCP parameters.

Procedure 109

Entering IP Phone boot parameters using partial DHCP parameters

1Power up the IP Phone.

Within four seconds, the Nortel logo appears.

2When the Nortel logo appears on the display, you have one second to press the four feature keys at the bottom of the display in sequence, from left to right.

Note: If the Nortel logo times out, repeat step 1 and step 2.

3For the following prompts:

a.Press the BKSpace (backspace) or Clear keys to change an entry.

b.Enter new values using the telephone’s keypad.

Communication Server 1000E Installation and Configuration