Nortel Networks 1000E warranty Controlling the baud rate, Mtc/Sch/Bug

Configuring a terminal and SDI ports Page 271 of 488

Controlling the baud rate

You can use a switch setting on the SSC’s faceplate to control the baud rate for port 0. Use LD 17 to configure port 1 and port 2. Make sure the baud rate and device option settings are set correctly.

•Use Port 0 for software installation and upgrades. Port 0 is the only system terminal (SDI) port that you can use for software installation and upgrades.

•You can use all three ports on the SSC to connect terminals or modems.

•Use an NTBK48 3-port SDI cable with the SSC.

Table 19 shows the SDI port numbering.

Table 19

SDI port numbering

Port	Use	Baud rate	Data bits	Stop bits	Parity
0	MTC/SCH/BUG	Set by a DIP switch	8	1	None
1	MTC/SCH/BUG	1200	8	1	None
2	MTC/SCH/BUG	1200	8	1	None

Communication Server 1000E Installation and Configuration