Nortel Networks 1000E warranty Standard 4.00 September

Page 486 of 488 Configuring IP Peer Networking and managing the Gatekeeper database

You must configure the following data when setting up a CS 1000E IP network:

1Configure the Virtual Trunk routes using Element Manager or the Command Line Interface (LD 16). Configure the Route Data Blocks and associate the Virtual Trunk routes with the IP network by configuring the following parameters:

a route information

b network management information (for example, Access Restrictions)

c bandwidth zone

d Signaling Server host name for the route e protocol identifier

f associated Node ID

2Configure the Virtual Trunks using Element Manager or the Command Line Interface (LD 14).

3Configure the network routing within the CS 1000E.

a Use existing tools to configure networking features, such as routing calls based on digits dialed.

b Configure dialing plan information for calls that must be routed to circuit-switched trunks (for example, PSTN interfaces). You can route these calls using a feature such as Network Alternate Route Selection (NARS). Configure Virtual Trunk routes in NARS the same way as traditional trunks.

4Configure the Primary, Alternate, and Failsafe Gatekeepers at installation and initial setup.

553-3041-210 Standard 4.00 September 2007