Nortel Networks 1000E warranty Procedure Logging in to the Signaling Server

Page 196 of 488 Installing and configuring the Signaling Server software

Procedure 45

Logging in to the Signaling Server

Before you begin, make sure the DTE–DTE null modem cable (supplied with the Signaling Server) runs between the serial port on the back of the Signaling Server and the maintenance terminal.

1Make sure the Signaling Server is powered up and connected to the maintenance terminal.

The Signaling Server must boot successfully before the user can log in.

2Press <CR> to invoke the login prompt.

3Enter the login credentials.

Note: If the Signaling Server has connected to the Call Server (the startup messages indicate if the PBX link is up), use the PWD1 login to access the Signaling Server.

a.Enter the default Signaling Server Command Line Interface (CLI) login admin.

b.Enter the Signaling Server Command Line Interface (CLI) password.

•If this Signaling Server has just been installed and you are logging in for the first time, enter the default password cseadmin.

The system immediately prompts you to change the default password.

•If this is not the first login to the Signaling Server, enter the appropriate password.

If you have forgotten the password, reset it from the Tools Menu (see Signaling Server: Installation and Configuration (553-3001-212).

End of Procedure

To log out of the Signaling Server, enter exit at the command line.

553-3041-210 Standard 4.00 September 2007