Nortel Networks 1000E warranty Bulkhead connector on a Media Gateway, End of Procedure

Page 234 of 488 Configuring a Small System Controller

3Install the 100BaseT daughterboard (single port) in slot 2 of the SSC:

a.Locate the alignment pin on the SSC.

b.Insert the alignment pin into the appropriate hole on the 100BaseT daughterboard (single port).

c.Secure the 100BaseT daughterboard (single port) using metal screw-downs on the SSC.

d.Route the NTDU0606 Ethernet cable through the plastic guides on the SSC.

4Install the SSC in the Media Gateway.

5Connect the NTDU0606 Ethernet cable to port 1 of the Media Gateway bulkhead connector shown in Figure 85 on page 234.

6Repeat Step 1 to Step 5 for each Media Gateway.

Figure 85

Bulkhead connector on a Media Gateway

Port 1

End of Procedure

553-3041-210 Standard 4.00 September 2007