Nortel Networks warranty MG 1000E SDI connection, MG 1000T SDI connection

Page 270 of 488 Configuring a terminal and SDI ports

•Parity - none

•Flow control - none

MG 1000E SDI connection

SDI connection to the MG 1000E is made at the back. See Figure 88 on page 272 for location of the 9-pin DTE (male) connector. It is modified to isolate pins 6, 7, and 8. Use PORT0 of NTBK48AA 3-port SDI cable for terminal connection.

Note: Connection must be made initially to each MG 1000E to set the

IP address.

MG 1000T SDI connection

A terminal, modem, or other device (such as CDR devices and additional TTYs) can be connected to the SDI ports. Follow Procedure 69 on page 272 to connect devices to Media Gateways.

Refer to Table 18 for SDI port numbering for MG 1000T Core and

MG 1000T Expansions.

Table 18

SDI port numbering for Media Gateways

Media Gateway	Normal mode		Survival mode
MG 1000T Core	0, 1,	2	N/A
MG 1000T Expansion 1	3, 4,	5	0, 1, 2
MG 1000T Expansion 2	6, 7,	8	0, 1, 2
MG 1000T Expansion 3	9, 10,	11	0, 1, 2
MG 1000T Expansion 4	12, 13, 14		0, 1, 2

553-3041-210 Standard 4.00 September 2007