Nortel Networks 1000E warranty Element Manager System Administration, Application configuration

Page 186 of 488 Installing and configuring the Signaling Server software

10Configure the application configuration for this Signaling Server. See Figure 63.

•If the Set TPS, Virtual Trunk TPS, and optional Network Routing Service (NRS) applications are to be enabled on this Signaling Server, enter a at the prompt to configure this Signaling Server as a co-resident Signaling Server.

•If only the NRS is to be enabled on this Signaling Server:

—If this Signaling Server is to be associated with a Call Server, enter a at the prompt to configure this Signaling Server as a co-resident Signaling Server. After you finished installing the Signaling Server software, you can disable the Set TPS and Virtual Trunk TPS in Element Manager (refer to

Element Manager: System Administration (553-3001-332)).

—If this Signaling Server is not to be associated with a Call Server, enter b at the prompt to set this Signaling Server as a stand-alone Signaling Server.

Figure 63

Application configuration

CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)

=====================================================================

Please select the application configuration for this Signaling Server.

Please enter:

<CR> -> <a> - Co-resident (LTPS + VTRK + NRS).

<b> - Stand-alone (NRS only - no Call Server). <q> - Quit.

Enter Choice>

553-3041-210 Standard 4.00 September 2007