Nortel Networks 1000E warranty Where Xx = port number Standard 4.00 September

Page 262 of 488 Connecting a Terminal Server

5Enable autoconnect for the port. Enter the command:

DEFINE PORT xx AUTOCONNECT ENABLED

Where:

xx= port number

6Enable autodedicate for the port. Enter the command:

DEFINE PORT xx AUTODEDICATED ENABLED

Where:

xx= port number

7Define a user name for the port. Enter the command:

DEFINE PORT xx USERNAME “ptyxx”

Where:

xx= port number

ptyxx = User Name is the pty port set during Call Server configuration for rlogin connection. The pty port is set using LD 17. For example, in LD 17, configure TTY 2 as pty. The port # username on Terminal Server becomes "pty2", not "PTY2" or "pty02".

Note 1: Ignore the following MRV information message during using DEFINE command. "In-Reach -729- Parameter cannot be modified by a set command". This is informational only that you must use DEFINE and not the more general SET command. It is not an error.

Note 2: The quotation marks (““) are also required around "PTYxx"

8Log out of the port. Enter the command:

LOGOUT PORT xx

Where:

xx = port number

553-3041-210 Standard 4.00 September 2007