Appendix E Configuration Menus IPmux-1/1E Installation and Operation Manual
E-54 Ethernet Configuration/Status – with Ethernet User Port
Table E-33. VLAN Configuration – User Tagged, User Untagged, Rate+User Untagged Modes
Parameter Values Remarks
VLAN ID 1 to 4094 Selects the VLAN to edit. Creates a VLAN entry if the
VLAN does not exist.
Network Yes
No
Network port is a member of VLAN
Network port is not a member
User1 Yes
No
User1 port is a member of VLAN
User1 port is not a member of VLAN
‘N’ pages between VLANs, ‘D’ deletes the current VLAN.
Table E-34. VLAN Configuration – Rate+User Tagged Mode
Parameter Values Remarks
VLAN ID 1 to 4094 Selects the VLAN to edit. Creates a VLAN entry if the
VLAN does not exist.
‘N’ pages between VLANs, ‘D’ deletes current VLAN
Network Yes
Always Yes. Switched automatically to Yes when moving
to this mode
Note: Network cannot be switched to No.
User1 Yes
No
Frames of the VLAN coming into the User1 port will
come out of the Network port (unless the policing
discarded them)
Frames of the VLAN coming into the User1 port will be
discarded.
• The maximum number of allowed entries is 16.
• In Rate+User Tagged mode, all the VLANs where User1 is YES, must either be in
the range 1–2047 or 2048–4094.
• In Tag mode, the Internal port is a member of VLANs used by bundle and
managers only.
• In Tag+RATE mode, the User1 port cannot be a member of a VLAN used by
bundle or manager – this is to remove the impression that the IPmux can
communicate through the User1 port in Tag+Rate mode.
• ‘N’ pages between VLANs, ‘D’ deletes the current VLAN.
Three ports are connected to the internal switch:
• Network
• User
• Internal (TDMoIP/Host).
For further details, see Ethernet User Port in Chapter 1.
Notes
Note