Cisco Systems MGX 8230 manual Port number is in the range

Chapter 6 Card and Service Configuration

ATM Universal Service Module (AUSM)

•port number is in the range 1–8.

•	vpi	has a value in the range 0–255.
•	vci	can be in the range 0–65535 for a VCC or * for a VPC.

•Conn type is the connection type: 0=VCC, and non-0 is the local ID of a VPC in the range 1–1000.

•Service Type is the service type: 1=CBR, 2=VBR, 3=Standard ABR, 4=UBR, 5=rt-VBR, and 6=ForeSight ABR.

•mastership is the mastership status of the endpoint: 1=master, and 2=slave. The default is slave, so you actually do not need to type a 2.

•Controller_Type is the optional controller specification: 1=PAR (the default}. 2=SPVC (PNNI).

• connID	is entered at only the master end and consists of the node name,
	slot number, port number, vci, and vpi of the slave end.

Note To migrate between ForeSight ABR and TM 4.0 ABR, the connections must be manually deleted and then re-added. This migration is not possible at run-time.

Step 2 To configure usage parameter control (UPC) for the connection (channel), use cnfupccbr, cnfupcvbr, cnfupcrtvbr, cnfupcabr, or cnfupcubr. Use dspcons to obtain the channel number.

cnfupccbr <port.vpi.vci> <enable/disable> <pcr[0+1]> <cdvt[0+1]> <IngPcUtil> <EgSrvRate> <EgPcUtil>

•port.vpi.vci identifies the connection.

•enable/disable is the UPC enable: 1=disable, 2=enable.

•pcr[0+1] is the peak cell rate. Without IMA, the range is as follows:

–T1, 10–3622 cells per second

–E1, 10–4528 cells per second

–clear E1, 10–4830 cells per second

For IMA, multiply the line rate by the number of links.

•cdvt[0+1] is the cell delay variation tolerance for cells with CLP=0 and

CLP=1. The range is 1–250000 microseconds.

•IngPcUtil is the percent utilization on the ingress. The range is 1–127. The default is 0.

	Cisco MGX 8230 Edge Concentrator Installation and Configuration
6-18	Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001