Cisco Systems MGX 8230 manual Par, PXM1-UI, Pxm-Ui, Rpm

2-24

3-14

4-12

3-17

6-43

6-43

Index

from AUSM/B line 6-14

O

on-line firmware, see run-time firmware 5-4overview of MGX 8220 1-2

P

PAR
resource partitioning on PXM				5-6,6-2
physical line
activating through the CLI on PXM					5-10
physical lines
activation, PXM		6-5
Portable AutoRoute, see PAR			5-6,6-2
power entry module		1-7
power requirements		3-2
Power system in MGX 8230 1-6
PXM
creating logical ports through the CLI					5-10
front card installation, warnings				2-1
port 34 5-11
port-level resource partitioning				5-11
specifying IP addresses 5-4
PXM1
Processor Switching Module			1-12
PXM1-UI
Processor Switch Module User Interface						1-13
PXM cell bus
Also see PXM	1-10
PXM-UI
alarm outputs	2-6
installation 2-1
user-control and access ports			5-3
PXM User Interface back card, see PXM-UI						2-1

R

reboot command 5-5

receive direction, relative to MGX 8230 B-1redundancy

1 to N for AUSM T1 and E1 6-14

FRSM E1 mode	6-27
FRSM T1 mode	6-27
redundancy back cards
R-RJ48-8E1 6-43

R-RJ48-8T1 6-43

Related documentation for IGX 8450 xxii

remoteConnId	6-11
Remove 4-7
Removing back cards		4-8
Removing front cards		4-7
resource partitioning
definition	6-1
definition for PXM		5-6

port-level, PXM 5-11

RJ48-8E1 6-43

RJ48-8T1 6-43

Route Processor Module

RPM 1-15

RPM

Route Processor Module 1-15

R-RJ48-8E1

R-RJ48-8T1

run-time firmware, see firmware download 5-4

S

safety

power and ground

SAFETY GROUND seismic mounting seismic stability plate 3-14

serial line interface protocol, see SLIP 5-3service interworking

	Cisco MGX 8230 Edge Concentrator Installation and Configuration
Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001		IN-5