Cisco Systems MGX 8230 manual Commands are cnfport, dspports, and delport

Chapter 5 Configuring the MGX 8230 Shelf

MGX 8230 MGX to BPX Feeder

Step 3 Optionally, modify the resource partitioning for the whole card by executing the cnfcdrscprtn command. You can view resource partitioning through dspcdrscprtn.

cnfcdrscprtn <number_PAR_conns> <number_PNNI_conns> <number_TAG_conns> number_PAR_conns is the number of connections in the range 0–32767 available to PAR. number_PNNI_conns is the number of connections in the range 0–32767 available to PNNI. number_TAG_conns is the number of connections in the range 0–32767 available to Tag.

For example, you could reserve 10,000 connections for each controller on the MGX 8230 PXM with: cnfcdrscprtn 10000 10000 10000

Note In this release, there is no need to partition MGX 8230 PXM resources.

Step 4 Activate the uplink line by executing addln according to the following syntax: addln -ds3 <slot.line> -e3 <slot.line> -sonet <slot.line>

where:

•-ds3 indicates a T3 line

•-e3 indicates an E3 line

•-sonetindicates an OC-3 or OC-12 line

•slot is always 1 for the MGX 8230 PXM whether the active MGX 8230 PXM is in slot 1 or 2

•line has the range 1–4 but depends on the number of lines on the uplink card

	You can activate only one MGX 8230 PXM line for the feeder application.
Step 5	If necessary, you can configure line characteristics by using the cnfln command.
Step 6	Create logical ports for the physical line by executing addport once for each logical interface. (Related
	commands are cnfport, dspports, and delport.)
	addport <port_num> <line_num> <pct_bw> <min_vpi> <max_vpi>
	port_num is the number for the logical port. The range is 1–32 for standard connections, and 34 is the
	port number reserved for inband ATM PVCs for network management.
	line_num is the physical line in the range 1–N. N is the number of lines on the card.
	pct_bw is percentage of bandwidth. The range is 0–100. This parameter applies to both ingress and
	egress.
	min_vpi is the minimum VPI value. The range is 0–4095.
	max_vpi is the maximum VPI value. The range is 0–4095.
Step 7	Optionally use cnfportrscprtn to specify the resources that a controller has on a port:
	cnfportrscprtn <port_no> <controller> <ingress_%BW> <egress_%BW>
	<min_VPI> <max_VPI> <min_VCI> <max_VCI> <max_GLCNs>
	port_no is the number for the logical port in the range 1–32 for user-connections or 34 for inband ATM
	PVCs for network management.
	controller is a string identifying the network controller—”PAR,” “PNNI,” or “TAG.”
	ingress_%BW is the percentage of ingress bandwidth—a number in the range 0–100.
	egress_%BW is the percentage of egress bandwidth—a number in the range 0–100.
	Cisco MGX 8230 Edge Concentrator Installation and Configuration
Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001		5-11