Cisco Systems MGX 8230 manual Cnfchanfst port.vpi.vci enable fgcraenable ibs pcr mcr icr

Chapter 6 Card and Service Configuration

ATM Universal Service Module (AUSM)

•EgSrvRate is the egress service rate. Without IMA, the range is as follows:

–T1, 10–3622

–E1, 10–4528

–clear E1, 10–4830

For IMA, multiply the line rate by the number of links.

•EgrPcUtil is the percent utilization on the ingress. The range is 1–127. The default is 0.

•clp_tag is the enable for CLP tagging: 1=disable, 2=enable.

cnfupcubr <port.vpi.vci> <enable> <pcr[0+1]> <cdvt[0+1]> <IngPc> <util> <clp_tag>

•port.vpi.vci identifies the connection.

•enable is the enabled/disable for UPC: 1=Disable, 2=Enable.

• pcr	is the peak cell rate. Without IMA, the range is:
	T1, 10–3622
	E1, 10–4528
	clear E1, 10–4830
	For IMA, multiply the line rate by the number of links.

•cdvt cdvt[0+1] is the cell delay variation tolerance for cells with CLP=[0+1]. The range is 1–250000 micro seconds.

• scr	is the peak cell rate. Without IMA, the range is:
	T1, 10–3622
	E1, 10–4528
	clear E1, 10–4830
	For IMA, multiply the line rate by the number of links.

•scr_police specifies the type of scr policing: 1= CLP[0] Cells, 2=CLP[0+1] cells, and 3=no SCR policing.

•mbs is the maximum burst size: the range is 1–5000 cells.

•IngPc is the percent utilization on the ingress. The range is 1–127. The default is 0.

•clp_tag is the enable for CLP tagging: 1=disable, 2=enable.

Step 3 Use cnfchanfst to configure the parameters for a ForeSight channel, if necessary.

•ForeSight ABR is a connection-level feature that require the Rate Control Feature to be enabled on the card.

cnfchanfst <port.vpi.vci> <enable> <fgcra_enable> <ibs> <pcr> <mcr> <icr>

	Cisco MGX 8230 Edge Concentrator Installation and Configuration
6-20	Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001