Chapter 4 Enclosure Installation

Installing a Stand-Alone MGX 8230

Installing a Stand-Alone MGX 8230

If the switch is a stand-alone unit, proceed directly to:

Connecting Power for DC Systems, page 4-11

Connecting Power for AC Systems, page 4-14.

If a lift is not available and the cards need to be removed, review the appropriate instructions to remove and replace modules in the “Install the MGX 8230 Without a Mechanical Lift (Optional)” section on page 4-7.

Rack Mounting an MGX 8230

To install the MGX 8230 into a 19- or 23-inch rack, follow the instructions outlined below:

Prepare for Rack Installation, page 4-3.

Install the MGX 8230 Using a Mechanical Lift (Recommended), page 4-6.

Install the MGX 8230 Without a Mechanical Lift (Optional), page 4-7.

Connecting Power for DC Systems, page 4-11.

Connecting Power for AC Systems, page 4-14.

Install the Cable Manager, page 4-17.

Power up the MGX 8230, page 4-18.

 

Cisco MGX 8230 Edge Concentrator Installation and Configuration

4-2

Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001

Page 134
Image 134
Cisco Systems MGX 8230 manual Installing a Stand-Alone MGX, Rack Mounting an MGX