Cisco Systems MGX 8230 manual =Cbr =Vbr =Abr =Ubr

Chapter 6 Card and Service Configuration

ATM Universal Service Module (AUSM)

•port_num is the logical port number in the range 1–8.

•q_num is the queue number in the range 1–16; 0 is the default for addchan.

1=CBR

2=VBR

3=ABR

4=UBR

•q_algo is a number to specify the queue algorithm:

0=disable queue

1=high priority—always serve 2=best available

3=minimum guaranteed bandwidth

4=minimum guaranteed bandwidth with maximum rate shaping 5=CBR with smoothing

•q_depth is the maximum queue depth in the range 1–16000 cells.

•clp_high is the high cell loss priority in the range 1–16000 cells.

•clp_low is the low cell loss priority in the range 1–16000 cells.

•efci_thres is the EFCI threshold in the range 1–16000 cells.

Step 6 If necessary, configure resources at the port level by executing cnfportrscprtn. Use dspportrscprtn to see the current resource partitioning.

cnfportrscprtn <port_num> <controller> <ingress_%BW> <egress_%BW> <number_of_cons> <VPImin/VPImax> [VCImin/VCImax]

•port_num is the port number in the range 1–8.

•controller is a number representing the controller: 1=PAR, 2=PNNI, and 3=MPLS.

•ingress_%BW is the percentage of ingress bandwidth in the range 0–100.

•egress_%BW is the percentage of egress bandwidth in the range 0–100.

•number_of_cons is the maximum number of connections on the port.

•VPImin/VPImaxis the minimum and maximum VPI numbers.

•VCImin/VCImax is the optional specification for VCI range.

	Cisco MGX 8230 Edge Concentrator Installation and Configuration
6-16	Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001