Chapter 6 Card and Service Configuration

Eight-Port Circuit Emulation Service Modules

Table 6-4 CESM Errors and Alarms (continued)

 

Alarm

Down

 

 

Error

Type

stream

Up Stream

Comments

 

 

 

 

 

Receive LOF

 

n/a

n/a

 

 

 

 

 

 

Receive AIS

Blue (AIS)

AIS (link)

FERF OAM

AIS over the T1 link or alternating 1s

 

 

 

cells

and 0s E1 link.

 

 

 

 

 

Configuring Service on an Eight-Port CESM

This section describes the steps for setting up a CESM and adding connections. The maximum number of connections is 248 on the MGX-CESM/B-8E1 and 192 on the MGX-CESM/B-T1. Use either the CLI or the Cisco WAN Manager application to set up a CESM and add connections. The following list shows the fundamental tasks and applicable CLI commands:

Optionally configure redundancy at the card level (addred and possibly addlink on the PXM1)

Optionally modify resource partitions at the card level (cnfcdrscprtn)

Activate a physical line (addln) and optionally configure the line (cnfln)

Create logical ports for structured data transport on a physical line (addport)

Optionally modify resource partitions at the port level (cnfportrscprtn)

Add connections by using addcon (or addchan if NSAP addressing is necessary)

For CESM-related commands, see the list of service module commands at the beginning of the Cisco MGX 8000 Series Command Reference. Also, each command description in the command reference lists related commands. For example, it shows display commands that relate to addition commands.

Configuring the Card, Lines, and Ports

This section describes how to configure parameters for the card, lines, and ports through the CLI. If you use the CiscoView application, refer to the CiscoView documentation. On the CLI, the command sequence is:

Step 1 addln <line number>

where line number is in the range 1–8. You can modify line characteristics with cnfln.

Step 2 Optionally execute cnfln to modify line characteristics from the defaults. (Use dspln or dsplns to check). The syntax for cnfln is:

cnfln <line_num> <line_code> <line_len> <clk_src> [E1-signalling]

line_num is a line number in the range 1–8

line_code is a number that specifies the line coding: 2=B8ZS (T1); 3=HDB3 (E1); and 4=AMI (T1/E1)

line_len is the line length: 10-15 for T1; 8 for E1 with SMB line module; 9 for E1 with RJ-48 line module

clk_src is a number specifying the clock source: 1 for loop clock; 2 for local clock

 

 

Cisco MGX 8230 Edge Concentrator Installation and Configuration

 

 

 

 

 

 

 

Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001

 

 

6-45

 

 

 

 

 

Page 213
Image 213
Cisco Systems MGX 8230 manual Configuring Service on an Eight-Port Cesm, Receive LOF Receive AIS Blue AIS AIS link