Cisco Systems MGX 8230 manual Service Type Default EgressQueue PXM1 Service Type

Chapter 6 Card and Service Configuration

Configuring Frame Relay Service

•remoteConnID is the connection identifier at the remote end and can have one the following formats according to the type of card at the slave endpoint:

NodeName.SlotNo.PortNo.DLCI

NodeName.SlotNo.PortNo.ControllerId.DLCI

Note ControllerId is a number indicating the type of network control application: 1=PAR, 2=PNNI, 3=TAG.

NodeName.SlotNo.PortNo.VPI.VCI for ATM endpoint

If the remote end is a PXM1, the port number can be in the range 1–32 for user connections or 34 for inband management connections (stand-alone node only).

•serv_type is the Channel Service Type: 1=high priority, 2=rt-VBR, 3=nrtVBR, 4=fstABR, 5=uBR, 9=stdABR

The Channel Service Type is used to provide the default egress queue mapping and PXM1 Service Type mapping:

Service Type	Default EgressQueue	PXM1 Service Type
HighPriority	Hi Priority	CBR
VBR-RT	Hi Priority	VBR-RT
VBR-NRT	Low Priority	VBR-NRT
ABR-FS	Low Priority	ABR-FST
STD-ABR	Low Priority	ABR-STD
UBR	Low Priority	UBR

For MGX-FRSM-HS1/B:

addcon <port_number> <DLCI> <CIR> <chan_type> <CAC> <Controller_type> <mastership> <connID>

•port_number is the logical port in the range 1–4.

•DLCI is the DLCI in the range 0–1023.

•CIR specifies the committed information rate. The range is 1–10000000 bps (although the V.35 version supports a maximum of 8 Mbps sustained).

•chan_type is a number that identifies the channel type: 1=NIW; 2=transparent SIW; 3=SIW with translation; 4=FUNI; 5=frame forwarding.

•CAC enables connection admission control.

•Controller_type identifies the network control application. The only valid type is the default of 1 (PAR).

•mastership indicates the mastership status for this end of the connection: 1=master; 2=slave.

•connID is the “remote” connection identifier from the slave end if you need to enter it at the master end. See “Rules for Adding Connections” for an explanation. The possible formats are:

–NodeName.SlotNo.PortNo.DlCI

–NodeName.SlotNo.PortNo.ControllerId.DlCI for Frame Relay end point.

	Cisco MGX 8230 Edge Concentrator Installation and Configuration
Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001		6-33