9-85
Cisco Router and Security Device Manager Version 2.2 User’s Guide
OL-4015-08
Chapter9 Easy VPN Remote
Edit Easy VPN Remote
Inside Interfaces
These are the inside interfaces included in this Easy VPN connection. All hosts
connected to these interfaces are part of the VPN.
Easy VPN Server
The names or IP addresses of the Easy VPN servers or concentrators. If the
Cisco IOS image on your router supports Easy VPN Remote Phase III, you can
identify two Easy VPN servers or concentrators during configuration using SDM.
Multiple Subnet Support
The addresses of subnets which are not directly connected to the router but which
are allowed to use the tunnel. An ACL defines the subnets allowed to use the
tunnel.
Tunnel Activation
Choose Auto, Manual, or traffic-based.
If the connection is configured with the Manual setting, you must click the
Connect button to establish the tunnel, but you can start or stop the tunnel at any
time by clicking the Connect or Disconnect button.
If the connection is configured with the Auto setting, the VPN tunnel is
established automatically when the Easy VPN configuration is delivered to the
router configuration file. However, the Connect or Disconnect button is not
enabled for this connection.
If the connection is configured with the traffic-based setting, the VPN tunnel is
established automatically when inside traffic qualifies for outside routing.
However, the Connect or Disconnect button is not enabled for this connection.
Backup Connection
A backup Easy VPN remote connection that has been set up. Backup connections
are configured in the SDM Interfaces and Connections task.
XAuth Response Method
If XAuth is enabled, the value shows one of the following about how the XAuth
credentials are sent:
•They must be entered from SDM or the router console
•They must be entered from a PC browser when browsing