Compaq LaserJet 4610n Detectable Size in Tray, Flash Device Failure, Flash File Operation Failed

Control panel messages (continued)

Control panel message

DETECTABLE SIZE IN TRAY X

For help press

alternates with

DETECTABLE SIZE

Recommend move switch to

STANDARD Event Log Empty

Description

The printer receives a print job for standard size media, but the tray switch is set to CUSTOM

SHOW EVENT LOG was selected from the control panel, and the event log is empty.

Recommended action

1.Press to see step-by-step information. Size specified is a standard size.

2.Move switch in tray to STANDARD

3.Confirm guieds are in the correct position.

4.To exit, press .

No action necessary.

FLASH DEVICE

FAILURE

To clear press

alternates with

Ready

FLASH FILE

OPERATION FAILED

To clear press

alternates with

Ready

FLASH FILE

SYSTEM IS FULL

To clear press

alternates with

Ready

FLASH IS

WRITE PROTECTED

To clear press

alternates with

Ready

Genuine HP supplies installed

A device failure has occurred on the specified drive. Printing may continue for jobs that do not require the Flash DIMM.

The printer received a PJL file system command that attempted to perform an illogical operation (for example, to download a file to a non-existent directory).

The printer received a PJL file system command that attempted to store something on the file system but was unsuccessful because the file system is full.

The file system device is protected and no new files can be written to it.

A new HP cartridge has been installed. The printer returns to the Ready state after approximately 10 seconds.

1.To clear the message, press the key.

2.Turn the printer back on.

3.If the message still persists, replace the Flash DIMM.

1.To clear the message, press the key.

2.If the message persists, turn the printer off and then back on.

3.If the message reappears, there may be a problem with the software application.

1.Use HP Web Jetadmin software to delete files from the Flash Memory and try again.

2.To clear the message, press the key.

3.If the message persists, turn the printer off and then back on.

1.To enable writing to the Flash Memory, turn off write protection, using HP Web Jetadmin.

2.To clear the message, press the key.

3.If the message persists, turn the printer off and then back on.

No action necessary.

140 Chapter 8 Problem solving ENWW