Compaq LaserJet 4610n Control panel message Replace Transfer KIT For help press, Request accepted

Control panel messages (continued)

Control panel message

REPLACE TRANSFER KIT For help press

alternates with

REPLACE TRANSFER KIT To continue press

Description

The transfer unit is nearing the end of its useful life and the SUPPLIES LOW setting in SYSTEM SETUP is set to STOP.

Recommended action

Continued

To reset the transfer unit count

1.Press MENU to enter the MENUS.

2.Press and to highlight

CONFIGURE DEVICE.

3.Press to select CONFIGURE DEVICE.

4.Press and to highlight RESETS.

5.Press to select RESETS.

6.Press and to highlight RESET SUPPLIES.

7.Press to select RESET SUPPLIES.

8.Press and to highlight NEW TRANSFER KIT.

9.Press to select NEW TRANSFER KIT.

10.Press and to highlight YES.

11.Press to select YES.

The transfer unit count is reset and the printer is ready to use.

Request accepted	The printer has accepted a request to
please wait	print an internal page, but the current job
	must finish printing before the internal
	page will print.

No action necessary.

Resend upgrade Resetting Kit Count

The firmware upgrade was not	Attempt upgrade again.
completed successfully.
YES is selected in the Reset Supplies	No action necessary.
menu, to reset the counts for any of the
supplies that cannot be detected as new.

Restoring...

Restoring...

factory settings Rotating <COLOR> motor

To exit press

STOP key

Rotating motor

To exit press

STOP key

The printer is restoring settings.

The printer is restoring factory settings.

A component test is in progress; the component selected is the <color> Cartridge motor.

The printer is executing a Component Test and the component selected is a motor.

No action necessary.

No action necessary.

Press STOP when ready to stop this test.

Press STOP when ready to stop this test.

Setting saved

A menu selection has been saved. No action necessary.

154 Chapter 8 Problem solving ENWW