Compaq LaserJet 4610n manual Type Mismatch Tray XX=TYPE, USE Tray XX Type Size

Control panel messages (continued)

Control panel message

TRAY XX SIZE= <SIZE>

Verify tray switch set to CUSTOM

alternates with

TRAY XX SIZE= <SIZE> then close tray

TYPE MISMATCH

TRAY XX=[TYPE]

For help press

alternates with

Ready

Description

A non-detectable media size was selected from the menu and the tray is open.

The selected size requires that the tray switch be set to CUSTOM, otherwise when the tray is closed, the tray size will change.

The media type loaded in the tray does not match the media type configured for the tray.

Recommended action

1.Adjust the side and rear media guides against the paper.

2.If the media used is letter, A4, executive, JIS B5, A5, or legal, the tray switch should be set to STANDARD. Set the tray switch to CUSTOM for all other media sizes. The tray switch must be set before the size can be selected from the control panel.

3.Close the tray.

1.Adjust the side and rear guides against the paper.

2.If size is a detectable size, set the tray switch to STANDARD, otherwise set the tray switch to

CUSTOM.

3.If necessary, press after the tray is closed to change the paper size or type.

Unable to mopy job

alternates with

Processing...

Unable to Store Job

alternates with

Processing...

USE TRAY XX [TYPE] [SIZE]

To change press /

To use press

Wait for printer to reinitialize

A Mopy job cannot be mopied because of a memory, disk, or configuration problem. Only one copy will be produced.

A job cannot be stored because of a memory or configuration problem.

The printer is offering a selection of alternate media to use for the print job.

RAM disk settings have been changed before the printer automatically restarts, or external device modes have changed or the printer is coming out of the diagnostics mode and will automatically restart.

Install additional memory in the printer.

Install additional memory in the printer.

1.View tray configurations (type and size) using and .

2.Press to select a tray to use.

No action necessary.

Warming up	The printer is coming out of PowerSave	No action necessary.
	mode. Printing will continue as soon as
	warmup is completed.

ENWW Control panel messages 157