Compaq LaserJet 4610n manual Installing memory

4.Using a #2 Phillips screwdriver, remove the eight screws holding the board in place, and set them aside.

5. Slide out the formatter board and set it on a clean, flat, grounded surface.

6.To replace a DDR DIMM that is currently installed, spread the latches apart on each side of the DIMM slot, lift the DDR DIMM up at an angle, and pull it out.

76* E0376* 28SE03 2P128S *2P1 *

7.Remove the new DIMM from the antistatic package. Locate the alignment notch on the bottom edge of the DIMM.

ENWW Installing memory 195