Compaq LaserJet 4610n manual Install Color Cartridge, Install Supplies

Control panel messages (continued)

Control panel message

INSTALL <COLOR>

CARTRIDGE

alternates with

For help press

The supplies gauge will display the consumption levels of print cartridges.

INSTALL SUPPLIES

For status press

The supplies gauge will display the consumption levels of print cartridges.

INSUFFICIENT MEMORY

TO LOAD FONTS/DATA

For help press

alternates with

Device

To continue press

LOAD TRAY 1: <TYPE> <SIZE> For help press

alternates with

LOAD TRAY 1: <TYPE> <SIZE> To continue press

LOAD TRAY XX [TYPE] [SIZE] For help press

Description

The cartridge is either not installed or not correctly installed in the printer.

At least one supply item is missing or is not correctly seated in the printer and another supply item is missing, incorrectly placed, out, or low. Insert the supply item or make sure the installed supply item is fully seated.

The device does not have enough memory to load the data, such as fonts or macros from the location specified. Device can be one of the following:

INTERNAL = ROM directly on the formatter board

CARD SLOT X = font card in slot X

DIMMS

Tray 1 is loaded and configured for a type and size other than the one specified in the job.

Tray XX is either empty or configured for a type and size other than specified in the job. No other tray is available.

Recommended action

1.Open the top cover and image transfer unit.

CAUTION

The image transfer unit can be easily damaged.

2.Insert the print cartridge and make sure that it is fully seated.

3.Close the front cover.

4.If the error persists, contact HP support at http://www.hp.com/ support/clj4610.

1.Press to access the SUPPLIES STATUS menu.

2.Press and to highlight the specific supply that has a problem.

3.Press to view help for the supply.

4.Press and to step through the instructions.

1.To use the device without the data, press .

2.To solve the problem, add more memory to the device. DDR SDRAM Memory: 128MB, (Q2630A) or 256MB (Q2631A).

1.If the correct paper is loaded, press

.

2.Otherwise, remove the incorrect paper and load Tray 1 with the specified paper.

3.Confirm that the media guides are in the correct position.

4.Verify that the tray switch is in the correct position.

5.To use another tray, remove paper from Tray 1 and then press .

1.Load the paper tray with the specified media.

2.Confirm that the media guides are in the correct position.

3.Verify that the tray switch is in the correct position.

142 Chapter 8 Problem solving ENWW