Compaq LaserJet 4610n manual Replace Transfer KIT, To select Reset Supplies

3. Slide the old unit out of the printer.

4. Install a new transfer unit.

5. Close the front and top covers.

NOTE

Control panel messages (continued)

Control panel message	Description	Recommended action
REPLACE TRANSFER KIT	The transfer unit is at end of life. Printing	1.	Open the top and front cover.
For help press	will not continue until the transfer kit has	2.	Remove the old unit by pressing the
	been replaced.
			blue buttons on either side of the unit.

If the old transfer unit was not at end-of- life when it was replaced (for example, if it was damaged), or if you want to continue printing past the end-of-life message, the transfer unit count must be reset using the printer control panel. Please note that the end-of-life message is provided as a customer service, and printing past it is likely to result in print quality degradation in the near future. Once the transfer kit count has been reset after an end-of-life message, feedback on the kit's remaining life will be incorrect until the kit is replaced and the count is reset again.

To reset the transfer unit count

1. Press MENU to enter the MENUS.

2. Press and to highlight

CONFIGURE DEVICE.

3. Press to select CONFIGURE DEVICE.

4. Press and to highlight RESETS.

5. Press to select RESETS.

6. Press and to highlight RESET SUPPLIES.

7.	Press	to select RESET SUPPLIES.
8.	Press	and to highlight NEW
	TRANSFER KIT.

9. Press to select NEW TRANSFER KIT.

10. Press and to highlight YES.

11. Press to select YES.

The transfer unit count is reset and the printer is ready to use.

152 Chapter 8 Problem solving ENWW