4.Using a #2 Phillips screwdriver, remove the eight screws holding the board in place, and set them aside.

5. Slide out the formatter board and set it on a clean, flat, grounded surface.

6.Align the groove on the side of the flash memory card with the notches in the connector and push it in the slot until it is fully seated.

CAUTION

NOTE

*2P128SE0376*

76* E0376* 28SE03 2P128S *2P1 *

Do not insert the flash memory card at an angle.

The flash memory slot marked "Firmware Slot" is reserved for firmware only.

ENWW

Installing memory 199

Page 211
Image 211
Compaq LaserJet 4610n manual 2P128SE0376 76* E0376* 28SE03 2P128S *2P1