Compaq LaserJet 4610n manual To continue press Description

Control panel messages (continued)

Control panel message

REPLACE TRANSFER KIT

For help press

alternates with

REPLACE TRANSFER KIT

To continue press

Description

The transfer unit is nearing the end of its useful life and the SUPPLIES LOW setting in SYSTEM SETUP is set to STOP.

Recommended action

1.Order the transfer kit.

2.To continue printing, press .

3.To replace the transfer kit, perform the following steps:

●Open the top and front cover.

●Remove the old unit by pressing the blue buttons on either side of the unit.

●Slide the old unit out of the printer.

●Install a new transfer unit.

●Close the front and top covers.

NOTE

If the old transfer unit was not at end-of- life when it was replaced (for example, if it was damaged), or if you want to continue printing past the end-of-life message, the transfer unit count must be reset using the printer control panel. Please note that the end-of-life message is provided as a customer service, and printing past it is likely to result in print quality degradation in the near future. Once the transfer kit count has been reset after an end-of-life message, feedback on the kit's remaining life will be incorrect until the kit is replaced and the count is reset again.

ENWW Control panel messages 153