Compaq LaserJet 4610n manual To continue press Description

Control panel messages (continued)

Control panel message

REPLACE FUSER KIT

For help press

alternates with

REPLACE FUSER KIT

To continue press

Description

The fuser is nearing the end of its useful life and the SUPPLIES LOW setting in SYSTEM SETUP is set to STOP.

Recommended action

1.Order the fuser kit.

2.To continue printing, press .

3.To replace the fuser kit, perform the following steps:

●Open the top cover.

●Loosen the blue thumb screws.

●Remove the old fuser unit.

●Install a new fuser unit and secure with thumb screws.

●Close the top cover.

NOTE

If you want to continue printing past the end-of-life message, the fuser kit count must be reset using the printer control panel. Please note that the end-of-life message is provided as a customer service, and printing past it is likely to result in print quality degradation in the near future. Once the fuser kit count has been reset after an end-of-life message, feedback on the kit's remaining life will be incorrect until the kit is replaced and the count is reset again.

To reset the fuser count

1.Press MENU to enter the MENUS.

2.Press and to highlight

CONFIGURE DEVICE.

3.Press to select CONFIGURE DEVICE.

4.Press and to highlight RESETS.

5.Press to select RESETS.

6.Press and to highlight RESET SUPPLIES.

7.Press to select RESET SUPPLIES.

8.Press and to highlight NEW FUSER KIT.

9.Press to select NEW FUSER KIT.

10.Press and to highlight YES.

11.Press to select YES.

The fuser count is reset and the printer is ready to use.

150 Chapter 8 Problem solving ENWW