Example Syntax

For example, you may want to specify the minimum and maximum warning thresholds for all temperature probes to 10 and 40° Celsius.

Example for SAS Controllers

In this example, the temperature probes reside in enclosure 3 attached to connector 2 on controller 1. To set the thresholds for all temperature probes to 10 and 40° Celsius, enter:

omconfig storage enclosure action=setalltempprobes controller=1 enclosure=2:3 minwarn=10 maxwarn=40

omconfig Reset All Temperature Probe Thresholds

Use the following omconfig command syntax to reset the minimum and maximum warning temperature thresholds back to their default value for all temperature probes in the enclosure.

NOTE: This command is not supported on SCSI RAID controllers.

Complete Syntax

omconfig storage enclosure action=resetalltempprobes controller=id enclosure=<ENCLOSUREID>

where id is the controller ID. The <ENCLOSUREID> variable specifies the enclosure.

Example Syntax

For example, you may want to reset the thresholds for all temperature probes in enclosure 2 on controller 1.

Example for SAS Controllers

In this example, the temperature probes reside in enclosure 3 attached to connector 2 on controller 1. To reset the thresholds for all temperature probes, enter:

omconfig storage enclosure action=resetalltempprobes controller=1 enclosure=2:3

omconfig Blink

Use the following omconfig command to blink the light-emitting diodes (LEDs) on the enclosure.

Complete Syntax

omconfig storage enclosure action=blink controller=id enclosure=

<ENCLOSUREID>

where id is the controller ID. The <ENCLOSUREID> variable specifies the enclosure.

184

Using the Storage Management Service

Page 184
Image 184
Dell Command Line Interface manual Omconfig Reset All Temperature Probe Thresholds, Omconfig Blink, 184